 |
Barrel threading, and custom suppressor designs.
Threading is $95.00 and includes a thread protector. custom suppressors are quoted after review.
There are many opinions on proper ways to thread a barrel for a suppressor. some will advise you to have it turned between centers and some will advocate the use of a 4 jaw chuck and indicator.
- What I have found to have the best results are to:
|
 |
I have seen the best results by
using a 4 jaw chuck on the muzzle and a spider on the chamber end. |
|
|
|
|
| ALL ORDERS MUST BE PAID IN FULL BEFORE SHIPPING |
|
 |
Suppressor Sound Testing
Let me start by saying not all published numbers for suppressors are accurate, It is possible to get some deviations at different times and under different conditions but lets face it, some companies are inherently dishonest.
read more
|
 |
MIL-STD-1474D Military Approved
I record a minimum of 3 ten shot strings at every testing session. These results are averaged. The result of this average is then added to the results from at least 3 other testing sessions, averaged again, as decibel reduction.
read more
|
 |
Special Testing Upon Request
If you have a special requirement I can perform sound test's to your specs and provide you the data. I have performed a test for several LE agencies where the SPL was recorded at the shooters right ear, left ear and center of the head. These customers were only purchasing suppressors to protect the officers hearing.
|
|
